windclock
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
windclock [2017/01/26 14:28] – givanbela | windclock [2017/05/15 14:35] (current) – givanbela | ||
---|---|---|---|
Line 5: | Line 5: | ||
// Current prototype development state: // | // Current prototype development state: // | ||
- | * installed a raspberry pi 3 with a sensehat | + | * installed a raspberry pi 3 with a sensehat |
* python coded all data for realtime request available in a file | * python coded all data for realtime request available in a file | ||
- | * installed localtunnel software for communication but it is dropping out (bug) | + | * managed to install a couple of working online transfers with the new websockets/ |
- | * so managed to install a couple of working online transfers with the new websockets/ | + | * also working on an enviro phat hat with a zero pi w |
- | * OH-NO! by upgrading to Python 3.5, the sensehat modules are not found, and have to reconfigure it all | + | |
// Future work: // | // Future work: // | ||
- | * then: adding a waterproof temperature and ambient light sensor by extending the sensehat header pins | + | * adding a waterproof temperature and ambient light sensor by extending the sensehat header pins |
* power: 5V-2A for the pi seems too much, so would use a Teensy with 3.3V 500mA (windclock-iv) | * power: 5V-2A for the pi seems too much, so would use a Teensy with 3.3V 500mA (windclock-iv) | ||
* designing a shape/case for hanging it up and responsive to wind (physical calibration) | * designing a shape/case for hanging it up and responsive to wind (physical calibration) | ||
- | * simple visualisation/ | + | * simple visualisation/ |
- | * work with more than one (but keep it under 10 haha) | + | * work with more than one windclock |
- | * client-side for data capture (katastrof interpretation and sonification) | + | * client-side for data capture (katastrof interpretation and sonification) |
// Make and install the real objects // | // Make and install the real objects // | ||
- | * rodchenko examples (see below) | + | * rodchenko examples (see below, as a starter) |
+ | * gtr-lahaag' | ||
* I would just cut out a spiral out of a thin wooden plate and stretch from the middle up | * I would just cut out a spiral out of a thin wooden plate and stretch from the middle up | ||
- | * gert's suggestions for design | + | * we'll ask more people and try them all out? that is greater fun! |
windclock.1485437306.txt.gz · Last modified: 2017/01/26 14:28 by givanbela